Connected Detectify is a motion detector for indoor purposes, based on a passive infrared technology sensor with a detection area up to 5 meters.
There are two versions available: a narrow 30 degree measuring beam for workstations and a wider one with a measuring beam over 90 degrees for rooms.
Network & Coverage
The devices use Sigfox 0g network, read more about it here.
Check the connectivity of Sigfox network in your location from these websites:
Globally via: https://www.sigfox.com/en/coverage
In Finland via: https://coverage.iniot.fi/
Installation for workstations
Please refer to the latest installation instruction from the device manufacturer’s website.
Installation for meeting rooms
1. Use a wide version for meeting rooms
2. Turn the power switch on by using a paperclip or a small screwdriver to slide the switch to I position
3. Scan the QR code or enter the sensor ID manually with Optimaze Inventory
4. Place the sensor to face towards the area, where the people will most likely be
5. Attach the hinge to the wall and make sure the hinge is pointing to metal support structure (if any)
Attach the sensor device to screw plate pins so that the antenna is pointing away from metal and twist gently clockwise until device locks in place
You can adjust the angle of the sensor with the hinge
Finally tighten the hinge screw