Add occupancy sensors

  1. Tap a capacity object (circle with black border) on the floor plan

  2. Add a new sensor by tapping the + Add Sensor button

  3. Point the phone to the sensor's QR code. Alternatively, tap Enter code and enter the code manually. The code is case sensitive.
  4. The capacity object is colored based on the connectivity status of the sensor:

    • time stamp: time of the last received data from the sensor

    • yellow =  sensor has not sent any data yet

    • green = sensor has sent data in the past 25 hours

    • red = last sensor update was more than 24 hours ago, which probably means the device battery is empty

    • white with + icon = no sensors have been added to the capacity object


  • You can add another sensor to the same object or add a sensor to another object by selecting a new object

  • The number on the capacity object shows how many sensors has been added in the location
  • Sensor messages are automatically refreshed every 30 seconds or manually by clicking the  button

  • You can close a capacity object by tapping outside the bottom panel


Remove occupancy sensors

  1. Select a capacity object that has a sensor installed

  2. Press the sensor ID a few seconds

  3. Tap Remove in the confirmation dialog

  • If you added a sensor to incorrect capacity object by mistake, select a new object and add the sensor to it. The sensor will automatically be removed from the previous object.

  • A sensor can only be added to one capacity object at a time