Add occupancy sensors
Select Tap a capacity object (grey circle ) to add a sensorwith black border) on the floor plan
Add a new sensor by clicking 'tapping the + Add Sensor' button.
- Point the phone to the sensor's QR code. Alternatively, tap Enter code and
Select ‘Scan QR code' or 'Enter code’
If you enter the code manually, it . The code is case sensitive. The capacity object is colored based on the latest received message from connectivity status of the sensor:
time stamp: time of the last received message data from the sensor
blue yellow = motion detectedsensor has not sent any data yet
green = no motion detected
orange = the system has not received any message from the sensor
sensor has sent data in the past 25 hours
red = last sensor update was more than 24 hours ago, which probably means the device battery is empty
white with + icon grey = no sensors have been added to the capacity object
You can add another sensor to the same object or add a sensor to another object by selecting a new object
- The number on the capacity object shows how many sensors has been added in the location
Sensor messages are automatically refreshed every 30 seconds or manually by clicking the the
button
You can close a capacity object by clicking that object or by swiping the selection pane from bottom-uptapping outside the bottom panel
Remove
Delete occupancy sensors
Select a capacity object that has a sensor installed
Press the sensor ID a few seconds
With iPhone you can delete a sensor also by by swiping the sensor ID to the left
Click 'Delete'
Tap Remove in the confirmation dialog
If you added a sensor to a wrong incorrect capacity object by mistake, select a new object and add the sensor to it. The sensor will automatically be deleted removed from the previous object.
A same sensor can only be added to one capacity object at a time
