Occupancy sensor devices detect motion indoors.
Installation process
Connected Detectify
Connected Detectify is a motion detector for indoor purposes, based on a passive infrared technology sensor with a detection area up to 5 meters.
There are two versions available: a narrow 30 degree measuring beam for workstations and a wider one with a measuring beam over 90 degrees for rooms.
You need for the installation:
Optimaze Inventory app in your mobile phone
Access to Optimaze Portal
Tools for the installation:
Ladder
Drill
Screws
Double-sided tape
Network & Coverage
Connected Detectify devices use Sigfox 0g network, read more about it here.
Check the connectivity of Sigfox network in your location from these websites:
Globally via: https://www.sigfox.com/en/coverage
In Finland via: https://coverage.iniot.fi/
Installation for workstations
Please refer to the latest installation instruction from the device manufacturer’s website: https://www.connectedfinland.fi/en/products/connected-detectify/
Use a narrow version for workstations
Turn the power switch on by using a paperclip or a small screwdriver to slide the switch to I position
Please note that the switch should slide relatively effortlessly. Do not use excess force to slide the switch!
Scan the QR code or enter the sensor ID manually with Optimaze Inventory
Attach a screw plate underneath the table top in the middle approx. 15 cm from the table top front. Use screws or double-sided tape for the attachment.
Attach the sensor to the screw plate. The sensor’s antenna is located below the QR code sticker. Always place the sensor so that the antenna is not directly facing metal.
Installation for meeting rooms
Use a wide version for meeting rooms
Turn the power switch on by using a paperclip or a small screwdriver to slide the switch to I position
Please note that the switch should slide relatively effortlessly. Do not use excess force to slide the switch!
Scan the QR code or enter the sensor ID manually with Optimaze Inventory
Place the sensor to face towards the area, where the people will most likely be
Attach the hinge to the wall and make sure the hinge is pointing to metal support structure (if any)
Attach the sensor device to screw plate pins so that the antenna is pointing away from metal and twist gently clockwise until device locks in place
You can adjust the angle of the sensor with the hinge
Finally tighten the hinge screw
